I can tell you ...
by Timmee

... the part number for the Intimidator's 12 point connector is a Molex 51110-1250-P (at least according to the packaging it came in), and the connector pins are Molex 50394-8100-C. Not sure about the 14 point connector, but the pins should be the same.



Digikey part numbers enclosed
by defiance

These aren't the stock parts, these are the ones used on the "wicked" eye set. Which, actually, are slightly better matched, but certainly are NOT worth $15, as you can see from their digikey pricing

2-sided eye emitter: QED522-ND
2-sided eye detector: QSD722-ND

Pretty sure...
by FlipFlops

On the 12 pin connector while looking straight down at it (with the pins coming out at you, not looking at the back side):

pin 12 pin 11
pin 10 pin 9
pin 8 pin 7
pin 6 pin 5
pin 4 pin 3
pin 2 pin 1

1 - membrane button
2 - membrane button
3 - ground for membrane buttons
4 - emitter diode power
5 - empty
6 - receiver diode power
7 - ground for eyes
8 - empty
9 - empty
10 - empty
11 - empty
12 - empty

Pin 6 will be below 1 volt for when the eyes are not blocked, and up around 3.5-4 volts when the eyes are blocked.

On the 14 pin connector:

pin 14 pin 13
pin 12 pin 11
pin 10 pin 9
pin 8 pin 7
pin 6 pin 5
pin 4 pin 3
pin 2 pin 1

1 - solenoid (negative)
2 - solenoid (positive)
3 - LED 1
4 - LED ground
5 - trigger (positive)
6 - trigger (negative)
7 - empty
8 - LED 2
9 - empty
10 - empty
11 - power switch
12 - power ground
13 - empty
14 - empty

At least, I'm pretty sure that's it, from what I've mapped out and tested on a stock SOB board using a multimeter.Posted on Feb 16, 2004, 3:31 PM

I just measured the LPR threads on a Timmy SCM3 to be 1"-20.